Alarm.Com MyQ Bedienungsanleitung PDF herunterladen (Seite 25)

Total Connect 2.0 Online Help Guide

– 23 –

Automation helpful hints

There are many configuration options in the Automation module, some can be configured at the LYNX Touch

control, but it is much easier to perform all these tasks from Total Connect. Manual control of your automa-

tion devices is easily done from the automation module. The same is true for creating and editing simple

scenes.

However there are times when a more detailed scene is desired. As you get familiar with creating and run-

ning simple scenes, you will be ready to create more detailed scenes. Below are a collection of functions that

more advanced users should be aware of.

General

• Only those features offered by the Z-Wave device will appear.

• When necessary, left and right scroll arrow buttons will appear to view more devices.

Thermostat:

• Thermostat name is limited to 13 characters.

• Thermostat and Fan mode buttons will toggle through their different modes. If the mode button is held a

pop-up list of possible modes will appear.

• When auto mode is selected, Dual set points will appear.

• When a thermostat set point is changed, the thermostat will stay at that temperature until the next set

point time.

• If the Hold button is selected, the thermostat will stay at that temperature until either the hold button is

pressed again, or any other thermostat property is changed. In that case the Hold button will deselect.

Locks, Switches, Dimmers, and Outlets:

• These devices can be dragged to the desired order.

• An “X” will appear for any device that is not connected.

• If you have a Z-Wave door lock, a jammed condition will be sensed and will appear in the “Events, Rules

& Notifications” module. This condition can be configured as an email notification.

Scenes:

• You can create up to 20 scenes with a total limit of 47 devices. Each scene is limited to 4 locks, 3 ther-

mostats, and 40 lights/switches. (Actual limits are determined by the LYNX Touch control.)

• After creating a new scene, use the green run button to test the scene.

• When in the “Quick Control” mode (button on the Automation module), the you will see a series of

scenes. Just click on the scene to run it.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 49 50

Keine Kommentare

Alarm.Com MyQ Bedienungsanleitung Seite 25