Alarm.Com MyQ Bedienungsanleitung PDF herunterladen (Seite 6)

LiftMaster MyQ® | Installation Guide

Appendix

Connect to Alarm.com using Dealer Site

Note: You cannot register MyQ® Garage through Alarm.com if it is already

registered through MyQ®/Liftmaster/Chamberlain or other similar apps. (See

“Additional Resources”)

Make sure the LED on the Hub is green before registering through the

Alarm.com Dealer Site.

Find and select the customer you’d like to connect with the Wi-Fi Hub.

Select service plan on the left and add the “Garage Door Control” and

“LiftMaster Integration” add-ons to the account’s service plan (Service

Plan -> Change Service Plan).

5) Use the tabs to navigate to the emPower equipment page (Equipment ->

emPower Devices) and select the LiftMaster section.

6) Select “Add Gateway” and enter the Wi-Fi Hub’s serial number.

The serial number can be found at the back of the Hub below the

barcode. Please wait patiently as this process may take several minutes.

7) After a few minutes, the equipment page should show the LiftMaster

Gateway in the equipment list.

8) Select “Add Device” for the Wi-Fi Hub that was just added. You may need

to refresh the page first.

9) Follow the instructions presented to add door sensor(s) and garage door

opener(s) to the system.

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Alarm.Com MyQ Bedienungsanleitung Seite 6